Step 9 – Your programming has been completed. Step 8 – Turn your vehicle off and then click the Ignition is Off button. Do not turn anything off, let your computer go to sleep, or battery die! Step 7 – The ECU programming sequence will go through.
Click open and the programming process will begin.
Then select the tuned file from your computer where it was saved. Step 4 – Click Software Options and then check the button that says “Do Not correct the checksum… Hit OK. Once you receive your file back, relaunch the program, turn your vehicle ignition on, and follow steps 1 – 3 and proceed below. At this point you can turn everything off and wait for us to send you back your tuned file. Once done, upload this image and your vehicle information using upload form ( CLICK HERE UPLOAD ). Take a screen shot of this image on your computer showing the software number. Once the cable is locked, it cannot be used on any other vehicles. Step 3 – Click the next button and lock your cable to this VIN and protocol. Step 2 – You will see an “error” like the screenshot below. Step 1 – Launch the program and with the cable connected to the vehicle and your computer, follow the prompts. We will then find a matching software number for your vehicle and send you back a tuned file. Do a screenshot of STEP 3, then upload that jpg, png, gif, or bmp to us. Connect to your vehicle and go through the prompts. NOTE: The Canam Rotax ME17 ECU can only be ID and not read out. Please make sure to disable ANY antivirus software and screensavers for the reading out and flashing process. We do recommend turning off any virus protection, screen savers, and closing all other programs during the writing process.
Each OS does install drivers differently so if you encounter a problem, please contact us.
Once you install the program, access your device manager and update the driver or replace it with this one here. Windows 7 requires a different driver.Because you need to connect the cable from your car to your computer, a Laptop or Tablet is required and should be plugged in while doing the process. This can be any PC and we have heard of Mac’s working if booted up as a Windows machine. Computer – You need to have a computer to install the flash client and connect the USB cable to.The software is available on the download link below. This is program is installed like any program on your computer as a.
It uses a mini USB to standard USB cable that plugs into your computer.